Subaru 2006 Legacy, Руководство пользователя

Страница: 2703 / 4302

EN(H6DO)(diag)-30
Subaru Select Monitor
ENGINE (DIAGNOSTICS)
5. READ CURRENT DATA FOR ENGINE (OBD MODE)
1) On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES]
key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {OBD System} and press the [YES] key.
5) On the «OBD Menu» display screen, select the {Current Data Display/Save}, and then press the [YES]
key.
6) On the «Data Display Menu» screen, select the {Data Display} and press the [YES] key.
7) Using the scroll key, scroll the display screen up or down until the desired data is shown.
• A list of the support data is shown in the following table.
Front oxygen monitor 2 Front oxygen monitor 2 — Rich
Knocking signal Knock signal — No
Crankshaft position sensor signal Crankshaft angle signal — Yes
Camshaft position sensor signal Camshaft angle signal — Yes
Pressure control solenoid valve signal PCV Solenoid — OFF output (when OFF)
Drain valve signal Vent Control Solenoid — OFF output (when OFF)
Rear defogger switch signal Rear Defogger SW — OFF input (when OFF)
Blower fan switch signal Blower fan SW — OFF input (when OFF)
Light switch signal Light SW — OFF input (when OFF)
Wiper switch signal Wiper SW — OFF input (when OFF)
A/C lock signal A/C lock signal — OFF input
A/C middle pressure switch signal A/C middle pressure SW — OFF input
A/C compressor relay signal A/C compressor relay output — OFF output
AT coordinate retard angle demand signal
AT coordinate retard angle
demand
— No
AT coordinate fuel cut demand signal
AT coordinate fuel cut
demand
— No
Vehicle dynamics control (VDC) torque down
prohibition output VDC torque down prohibition
output
— ON
Vehicle dynamics control (VDC) torque down
demand
VDC torque down demand — No
AT coordinate permission signal
AT coordinate permission
signal
— ON
Electronic throttle control motor relay signal ETC motor relay — ON
Stop light switch signal Stop light SW — OFF
SET/COAST switch signal SET/COAST SW — OFF
RESUME/ACCEL switch signal RESUME/ACCEL SW — OFF
Brake switch signal Brake SW — OFF
Main switch signal Main SW — OFF
Body integrated unit data reception Body Int. Unit Data — ON
Body integrated unit counter update Body Int. Unit Count — ON
Cruise control cancel switch signal CC Cancel SW — OFF
Variable valve lift diagnosis oil pressure switch
signal 1
Oil Temperature SW1 — ON
Variable valve lift diagnosis oil pressure switch
signal 2
Oil Temperature SW2 — ON
Remarks Display Unit of measure Note (at idling)
asieps_tobira.book 30 ページ ２００９年１０月２６日 月曜日 午前９時１６分