Subaru 2006 Legacy, Руководство пользователя

Страница: 3875 / 4302

DI-56
Rear Differential (VA-type)
DIFFERENTIALS
(3) Obtain the thickness of pinion height adjust-
ing washer to be inserted from the following for-
mula, and replace the temporarily installed
washer with this one.
NOTE:
Adjust it using the 1 — 3 washers.
T = To + N – 0.05 mm (0.0020 in)
(Example of calculation)
To = 0.15 mm (0.0059 in)
N = 0.1 mm (0.0039 in)
T = 0.15 mm (0.0059 in) + 0.1 mm (0.0039 in) –
0.05 mm (0.0020 in) = 0.2 mm (0.0079 in)
Result: Thickness = 0.2 mm (0.0079 in)
Therefore use part number 32295AA220.
3) Install the selected pinion height adjusting wash-
er on drive pinion, and press the rear bearing cone
into position with ST.
ST 498175500 INSTALLER
4) Insert the drive pinion into the differential carrier,
and install the preselected bearing preload adjust-
ing collar and washer.
5) Press-fit the front bearing cone into the carrier
with ST1, ST2 and ST3.
ST1 32285AA000 DUMMY COLLAR
ST2 399780104 WEIGHT
ST3 899580100 INSTALLER
6) Insert the collar, then press-fit the pilot bearing
with ST1 and ST2.
ST1 399780104 WEIGHT
ST2 899580100 INSTALLER
T Thickness of pinion height adjusting
washer mm (in)
To Thickness of washer temporally
inserted mm (in)
N Clearance of thickness gauge mm (in)
Memo:
Pinion height adjusting washer
Part No. Thickness mm (in)
32295AA200 0.150 (0.0059)
32295AA210 0.175 (0.0069)
32295AA220 0.200 (0.0079)
32295AA230 0.225 (0.0089)
32295AA240 0.250 (0.0098)
32295AA250 0.275 (0.0108)
ST
DI-00085
(A) Drive pinion
(B) Bearing preload adjusting collar
(C) Bearing preload adjusting washer
(D) Differential carrier
(D)
(A)
(B)
(C)
DI-00156
ST3
ST1
ST2
DI-00087
ST2
ST1
DI-00088
asieps_tobira.book 56 ページ ２００９年１０月２６日 月曜日 午前９時１６分