Subaru 2006 Legacy, Руководство пользователя

Страница: 3228 / 4302

4AT- 8 1
Converter Case
AUTOMATIC TRANSMISSION
31.Converter Case
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 4AT-35, REMOVAL, Automatic
Transmission Assembly.>
2) Pull out the torque converter assembly. <Ref. to
4AT-68, REMOVAL, Torque Converter Assembly.>
3) Remove the input shaft.
4) Lift-up the lever on the rear side of connector,
and then disconnect it from the stay.
5) Disconnect the inhibitor switch connector from
the stay.
6) Remove the oil charge pipe. <Ref. to 4AT-67,
REMOVAL, Oil Charge Pipe.>
7) Remove the oil cooler inlet and outlet pipes.
<Ref. to 4AT-63, REMOVAL, ATF Cooler Pipe and
Hose.>
8) Remove the converter case alignment bolt, and
then separate the transmission case and converter
case by lightly tapping with a plastic hammer.
NOTE:
• Be careful not to damage the oil seal and bush-
ing in the converter case with the oil pump cover.
• Be careful not to loosen the rubber seal.
9) Remove the seal pipe.
10) Remove the differential assembly. <Ref. to
4AT-95, REMOVAL, Front Differential Assembly.>
11) Remove the oil seal from converter case.
B: INSTALLATION
1) Check the appearance of each component and
clean them.
2) Press-fit the oil seal to converter case using ST.
ST 398437700 DRIFT
3) Install the differential assembly to the case.
<Ref. to 4AT-95, INSTALLATION, Front Differen-
tial Assembly.>
(A) Transmission connector
(B) Inhibitor switch connector
AT-00114
AT-01351
(B)
(A)
(A) Seal pipe
AT-00175
AT-00176
AT-00177
asieps_tobira.book 81 ページ ２００９年１０月２６日 月曜日 午前９時１６分