Subaru 2006 Legacy, Руководство пользователя

Страница: 1560 / 4302

EN(H4DOTC)(diag)-29
Subaru Select Monitor
ENGINE (DIAGNOSTICS)
6. READ FREEZE FRAME DATA FOR ENGINE (OBD MODE)
1) On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES]
key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {OBD System} and press the [YES] key.
5) On the «OBD Menu» display screen, select the {Freeze Frame Data} and press the [YES] key.
• A list of the support data is shown in the following table.
NOTE:
For detailed operation procedure, refer to the “SUBARU SELECT MONITOR OPERATION MANUAL”.
7. LED OPERATION MODE FOR ENGINE
1) On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES]
key.
3) Press the [YES] key after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}, and then press the
[YES] key.
5) On the «Data Display» screen, select the {Data LED Display} and press the [YES] key.
6) Using the scroll key, scroll the display screen up or down until the desired data is shown.
• A list of the support data is shown in the following table.
Description Display Unit of measure
DTC of freeze frame data Freeze frame data Diagnostic code
Air fuel ratio control system for bank 1 Fuel system for Bank1 —
Engine load data Engine Load %
Engine coolant temperature signal Coolant Temp. °C or °F
Short term fuel trim by front oxygen (A/F) sensor (Bank 1) Short term fuel trim B1 %
Long term fuel trim by front oxygen (A/F) sensor (Bank 1) Long term fuel trim B1 %
Intake manifold absolute pressure signal Mani. Absolute Pressure mmHg, kPa, inHg or psi
Engine speed signal Engine Speed rpm
Vehicle speed signal Vehicle Speed km/h or MPH
Ignition timing adv.#1 Ignition timing adv. #1 °
Intake air temperature Intake Air Temp. °C
Amount of intake air Mass Air Flow g/s
Throttle valve angle Throttle Opening Angle %
Remarks Display Message LED “ON” requirements
AT/MT identification signal AT Vehicle ID Signal ON or OFF Illuminate (AT model)
Test mode signal Test Mode Signal ON or OFF Test mode connector connected
Neutral position switch signal Neutral Position Switch ON or OFF
When neutral position signal is
input.
Idle switch signal Idle Switch Signal ON or OFF When idle switch signal is input.
Ignition switch signal Ignition Switch ON or OFF When ignition switch is turned ON.
Power steering switch signal P/S Switch ON or OFF
When power steering switch is
entered.
Starter switch signal Starter Switch ON or OFF When starter switch is input.
Air conditioning switch signal A/C Switch ON or OFF
When air conditioning switch is
input.
Rear oxygen sensor rich signal Rear O2 Rich Signal Lean or Rich
When rear oxygen sensor mixture
ratio is rich.
Knocking signal Knocking Signal Provided or None When knocking signal is input.
Crankshaft position sensor signal Crankshaft Position Signal Provided or None
When crankshaft position sensor
signal is input.
asieps_tobira.book 29 ページ ２００９年１０月２６日 月曜日 午前９時１６分