Subaru 2006 Legacy, Руководство пользователя

Страница: 3651 / 4302

CL-10
Clutch Disc and Cover
CLUTCH SYSTEM
2. Clutch Disc and Cover
A: REMOVAL
NOTE:
The illustration below is for a Turbo model. Howev-
er, perform the same procedures for the Non-turbo
model.
1) Remove the transmission assembly from vehicle
body. <Ref. to 5MT-24, REMOVAL, Manual Trans-
mission Assembly.>
2) Insert the ST on the flywheel.
ST 499747100 CLUTCH DISC GUIDE
3) Remove the clutch cover and clutch disc.
NOTE:
• Take care not to allow oil to touch the clutch disc
face.
• Do not disassemble the clutch cover or clutch
disc.
• Be sure to label alignment marks on the flywheel
and clutch cover before removing the clutch cover.
B: INSTALLATION
NOTE:
The illustration below is for a Turbo model. Howev-
er, perform the same procedures for the Non-turbo
model.
1) Insert the ST into the clutch disc and attach to
the flywheel by inserting the ST end into pilot bear-
ing.
NOTE:
When installing the clutch disc, be careful to attach
in the correct direction.
ST 499747100 CLUTCH DISC GUIDE
2) Install the clutch cover to the flywheel and tight-
en the bolts to the specified torque.
NOTE:
• When installing the clutch cover to the flywheel,
position the clutch cover in order to make the gap
between inbalance marks ( paint mark) of fly-
wheel and clutch cover 120° or more. (The inbal-
ance marks show the residual inbalance direction.)
• Note the front and rear of the clutch disc when in-
stalling.
• Tighten the clutch cover installing bolts gradual-
ly. Each bolt should be tightened to the specified
torque in a crisscross order.
Tightening torque:
16 N·m (1.6 kgf-m, 11.8 ft-lb)
3) Remove the ST.
ST 499747100 CLUTCH DISC GUIDE
(A) Dual mass flywheel
CL-00362
(A)
ST
CL-00363
(A) Flywheel side
CL-00364
(A)
ST
(A)
CL-00365
(1)
(2)
(3)
(4)
(5)
(6)
asieps_tobira.book 10 ページ ２００９年１０月２６日 月曜日 午前９時１６分