Subaru 2006 Legacy, Руководство пользователя

Страница: 3157 / 4302

ME(H6DO)-2 8
Valve Clearance
MECHANICAL
9) Turn the crankshaft clockwise until the cam is
set to position shown in the figure.
10) Measure the clearance of intake valve and ex-
haust valve using thickness gauge (A).
NOTE:
• Measure it within the range of
±
30° from speci-
fied position shown in the figure.
• Measure it in low lift cam for intake side.
• Insert a thickness gauge in a direction as hori-
zontal as possible with respect to the valve lifter.
Valve clearance
Intake:
0.20
+0.04
–0.06
mm (0.0079
+0.0016
–0.0024
in)
Exhaust:
0.35
±
0.05 mm (0.0138
±
0.0020 in)
• If the measured value is not within specification,
take notes of the value in order to adjust the valve
clearance later on.
11) If necessary, adjust the valve clearance. <Ref.
to ME(H6DO)-28, ADJUSTMENT, Valve Clear-
ance.>
12) Further turn the crank pulley clockwise and
then measure the valve clearances again.
13) After inspection, install the related parts in the
reverse order of removal.
B: ADJUSTMENT
1. INTAKE SIDE
CAUTION:
• Adjustment of valve clearance should be per-
formed while engine is cold.
• Do not wear gloves during removal and in-
stallation of valve lifter.
• Do not use valve lifters that were dropped or
otherwise exposed to strong impacts.
• When installing the valve lifter, align the anti-
rotation of valve lifter with groove on cylinder
head, and then insert the valve lifter.
1) Measure all the valve clearances.
<Ref. to ME(H6DO)-27, INSPECTION, Valve
Clearance.>
NOTE:
Record each valve clearance after measurement.
2) Remove the camshaft. <Ref. to ME(H6DO)-53,
REMOVAL, Camshaft.>
3) Remove the valve lifter.
4) Remove the shim from valve lifter.
5) Check the thickness of the shim from the mark-
ings on the side of the shim that was removed.
(1) Valve clearance (Intake side)
(2) Valve clearance (Exhaust side)
(3) High lift cam
(4) Low lift cam
ME-02565
(4)
(3)
(3) (4)
(1)
(2)
(1)
(2)
(23 ) (23 )
(A)
ME-00464
asieps_tobira.book 28 ページ ２００９年１０月２６日 月曜日 午前９時１６分