Subaru 2006 Legacy, Руководство пользователя

Страница: 3254 / 4302

4AT-105
AT Main Case
AUTOMATIC TRANSMISSION
13) Press the center of retaining plate by applying a
force of N using push/pull gauge, and then mea-
sure and record the height A. Measure at three lo-
cations or more spaced by equal distances and
take the average value.
NOTE:
If measuring in three locations, measure every
120°. If measuring in four locations, measure every
90°.
14) Installation of the low & reverse brake:
Install the dish plate, driven plate, drive plate and
retaining plate, and then secure them with a snap
ring.
NOTE:
Pay attention to the orientation of the dish plate.
15) Apply compressed air intermittently to check for
operation.
16) Place same thickness shims on both sides to
prevent plate from tilting, then measure and record
the clearance B.
NOTE:
Do not push in the shim down with force to a point
where the waves on the drive plate will be crushed.
17) Piston stroke calculation
Calculate with A and B dimensions recorded be-
fore. If the calculated value exceeds the service
limit, replace the drive plate with a new part and ad-
just it within the initial specification.
T = A + B
T: Piston stroke
A: Amount of drive plate compression
B: Clearance between retaining plate and snap ring
Initial standard:
2.15 — 2.65 mm (0.085 — 0.104 in)
Limit thickness:
2.95 mm (0.116 in)
(A) Dish plate
(B) Driven plate
(C) Drive plate
(D) Retaining plate
(A) Snap ring
AT-01721
(B)
(D)
(C)
(A)
A
AT-00294
( A )
Retaining plate
Part number Thickness mm (in)
31667AA420 3.8 (0.150)
31667AA320 4.1 (0.161)
31667AA330 4.4 (0.173)
31667AA340 4.7 (0.185)
31667AA350 5.0 (0.197)
31667AA360 5.3 (0.209)
31667AA370 5.6 (0.220)
31667AA380 5.9 (0.232)
AT-00297
AT-02216
B
asieps_tobira.book 105 ページ ２００９年１０月２６日 月曜日 午前９時１６分