Subaru 2006 Legacy, Руководство пользователя

Страница: 3978 / 4302

FS-10
Wheel Alignment
FRONT SUSPENSION
4. STEERING ANGLE
• INSPECTION
1) Place the vehicle on turning radius gauge.
2) While depressing the brake pedal, turn the steer-
ing wheel fully to the left and right. With the steering
wheel held at each fully turned position, measure
both the inner and outer wheel steering angles.
• ADJUSTMENT
1) Turn the tie-rod to adjust the steering angle of
both inner and outer wheels.
2) Check the toe-in.
NOTE:
Correct the boot if it is twisted.
5. FRONT WHEEL TOE-IN
• INSPECTION
Toe-in:
0
±
3 mm (0
±
0.12 in)
1) Set the toe-in gauge in the position at wheel axis
center height behind the right and left front tires.
2) Place a mark at the center of both left and right
tires, and measure distance “A” between the
marks.
3) Move the vehicle forward to rotate the tires 180°.
NOTE:
Be sure to rotate the tires in the forward direction.
4) Measure the distance “B” between the left and
right marks. Find toe-in using the following equa-
tion:
A – B = Toe-in
• ADJUSTMENT
When adjusting the toe-in, adjust it to the following
value.
Toe-in:
0
±
2 mm (0
±
0.08 in)
1) Check that the left and right wheel steering an-
gles are within specification.
2) Loosen the left and right side steering tie-rod
lock nuts.
3) Turn the left and right tie-rods by equal amounts
until the toe-in is at the specification.
Both the left and right tie-rods are right-hand
threaded. To increase toe-in, turn both tie-rods
clockwise by equal amount (viewing from the inside
of vehicle).
4) Tighten the tie-rod lock nut.
Tightening torque:
85 N·m (8.7 kgf-m, 62.7 ft-lb)
NOTE:
Check and correct the tie rod boot if twisted.
Model Inner wheel Outer wheel
OUTBACK 38.0°
±
1.5° 33.7°
±
1.5°
2.5i, 2.5GT 37.2°
±
1.5° 33.0°
±
1.5°
2.5 GT spec. B 33.8°
±
1.5° 30.2°
±
1.5°
(1) Lock nut
FS-00014
(1)
(1) Lock nut
FS-00015
A
B
FS-00014
(1)
asieps_tobira.book 10 ページ ２００９年１０月２６日 月曜日 午前９時１６分