Subaru 2006 Legacy, Руководство пользователя

Страница: 390 / 4302

EN(H4SO)(diag)-2 8
Subaru Select Monitor
ENGINE (DIAGNOSTICS)
NOTE:
For detailed operation procedure, refer to the “SUBARU SELECT MONITOR OPERATION MANUAL”.
Engine oil temperature Engine Oil Temperature °C
≥
85°C (After engine is
warmed-up.)
Oil switching solenoid valve duty R OSV Duty R % 16.9%
Oil switching solenoid valve duty L OSV Duty L % 16.9%
Oil switching solenoid valve current R OSV Current R mA 192 mA
Oil switching solenoid valve current L OSV Current L mA 192 mA
Variable valve lift mode VVL Lift Mode — 1
#1 cylinder roughness monitor Roughness Monitor #1 — 0
#2 cylinder roughness monitor Roughness Monitor #2 — 0
#3 cylinder roughness monitor Roughness Monitor #3 — 0
#4 cylinder roughness monitor Roughness Monitor #4 — 0
AT/MT identification terminal AT Vehicle ID Signal — AT vehicle/MT vehicle
Test mode terminal Test Mode Terminal — U-check
Neutral position switch signal Neutral Position Switch — Neutral
Soft idle switch signal Idle Switch Signal — At idle
Ignition switch signal Ignition Switch — ON input
Power steering switch signal P/S Switch — OFF input (At OFF)
Air conditioning switch signal A/C Switch — OFF input (At OFF)
Starter switch signal Starter Switch — OFF input
Rear oxygen monitor Rear O2 Rich Signal — Rich/Lean
Knocking signal Knocking Signal — None
Crankshaft position sensor signal Crankshaft Position Signal — Provided
Camshaft position sensor signal Camshaft Position Signal — Provided
Rear defogger switch signal Rear Defogger Switch — OFF input (At OFF)
Blower fan switch signal Blower Fan Switch — OFF input (At OFF)
Light switch signal Light Switch — OFF input (At OFF)
A/C middle pressure switch signal A/C Mid Pressure Switch — OFF input (At OFF)
Air conditioner compressor relay output signal A/C Compressor Signal — OFF output (At OFF)
Radiator fan relay 1 signal Radiator Fan Relay #1 — OFF output (At OFF)
Radiator fan relay 2 signal Radiator Fan Relay #2 — OFF output (At OFF)
Fuel pump relay signal Fuel Pump Relay — ON output
PCV hose assembly diagnosis signal
Blow-by Leak Diagnosis
Connector
— Connected
Pressure control solenoid valve signal PCV Solenoid Valve — OFF output
Drain valve signal Vent. Solenoid Valve — OFF output
Variable valve lift diagnosis oil pressure switch signal 1 Eng. Oil Press. SW 1 — ON
Variable valve lift diagnosis oil pressure switch signal 2 Eng. Oil Press. SW 2 — ON
AT coordinate retard angle demand signal Retard Signal from AT — None
AT coordinate fuel cut demand signal Fuel Cut Signal from AT — None
AT cooperative permission signal
Torque Control Permission
Signal
— ON
Electronic throttle control motor relay signal ETC Motor Relay — ON
Clutch switch signal Clutch Switch — OFF (At OFF)
Stop light switch signal Stop Light Switch — OFF (At OFF)
SET/COAST switch signal SET/COAST Switch — OFF (At OFF)
RES/ACC switch signal RESUME/ACCEL Switch — OFF (At OFF)
Brake switch signal Brake Switch — OFF input (At OFF)
Main switch signal Main Switch — OFF input (At OFF)
Integrated unit data reception Body Int. Unit Data — Provided
Body integrated unit counter update Body Int. Unit Count — Provided
Cruise control cancel switch signal Cruise Control Cancel Switch — OFF input (At OFF)
Remarks Display Unit of measure Note (at idling)
asieps_tobira.book 28 ページ ２００９年１０月２６日 月曜日 午前９時１６分