Subaru 2006 Legacy, Руководство пользователя

Страница: 3946 / 4302

DS-22
Front Drive Shaft
DRIVE SHAFT SYSTEM
6. Front Drive Shaft
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle, and remove the front wheels.
3) Drain the transmission gear oil. (MT model)
4) Drain the differential gear oil. (AT model)
5) Lift the crimped section of axle nut.
6) Remove the axle nut using a socket wrench
while depressing the brake pedal.
CAUTION:
Remove the wheel before loosening the axle
nut. Failure to follow this rule may damage the
wheel bearings.
7) Remove the stabilizer link from front arm.
8) Disconnect the front arm ball joint from the hous-
ing.
9) Remove the front drive shaft assembly. If it is
hard to remove, use ST1 and ST2.
ST1 926470000 AXLE SHAFT PULLER
ST2 28099PA110 AXLE SHAFT PULLER
PLATE
10) Using a bar, remove the front drive shaft from
transmission.
CAUTION:
Be careful not to allow the bar to damage holder
area.
B: INSTALLATION
1) Using the ST, replace the differential side retain-
er oil seal with a new seal.
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
NOTE:
After pulling out the drive shaft, be sure to replace
with a new oil seal.
2) Insert the EBJ into hub splines.
3) Draw the drive shaft into specified position.
CAUTION:
Do not hammer drive shaft when installing it.
4) Tighten the axle nut temporarily.
5) Using the ST, install the front drive shaft to trans-
mission.
ST 28399SA010 OIL SEAL PROTECTOR
6) Connect the front arm ball joint to the housing.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
7) Install the stabilizer link.
Tightening torque:
45 N·m (4.6 kgf-m, 33.2 ft-lb)
CAUTION:
Be sure to use a new self-locking nut.
DS-00038
FS-00106
DS-00145
ST2
ST1
MT-00103
ST
AT-00110
ST
asieps_tobira.book 22 ページ ２００９年１０月２６日 月曜日 午前９時１６分