Subaru 2006 Legacy, Руководство пользователя

Страница: 3182 / 4302

4AT-74
Transfer Clutch
AUTOMATIC TRANSMISSION
11) Apply vaseline to a new seal ring and attach to
the seal ring groove of the shaft.
NOTE:
While installing the seal ring, not to stretch the seal
ring excessively.
12) Install the transfer clutch assembly while taking
care not to damage the seal ring.
E: INSPECTION
• Inspect the drive plate facing for wear and dam-
age.
• Make sure the snap ring is not worn and the re-
turn spring has no permanent distortion, damage,
or deformation.
• Inspect the D-ring for damage.
• Inspect the extension end play, and adjust it to
within the standard value. <Ref. to 4AT-75, AD-
JUSTMENT, Transfer Clutch.>
1) Check clearance between the snap ring and
pressure gauge.
2) Before measuring clearance, place same thick-
ness shims on both sides to prevent the pressure
plate from tilting.
3) If the clearance exceeds the service limits, re-
place the plate set (drive plate and driven plate),
and select and adjust a pressure plate to be within
the initial standard value.
Initial standard:
0.7 — 1.1 mm (0.028 — 0.043 in)
Limit thickness:
1.6 mm (0.063 in)
4) Check for tight corner braking phenomenon
when the vehicle is moved forward with the steer-
ing fully turned. If tight corner braking occurs, per-
form the following procedures.
(1) With the steering wheel held at fully turned
position, drive the vehicle in “D” range and with
vehicle speed at approx. 5 km/h (3 MPH) in
both clockwise and counterclockwise directions
for approx. ten times each, while repeating ac-
celeration and braking intermittently.
(2) If the tight corner braking phenomenon still
persists, drive the vehicle again in a circle for
several laps.
(A) Seal ring
(B) Transfer clutch
(A) Transfer clutch
(B) Extension case
AT-00141
(A)
(B)
AT-00125
(A)
(B)
Pressure plate
Part number Thickness mm (in)
31593AA151 3.3 (0.130)
31593AA161 3.7 (0.146)
31593AA171 4.1 (0.161)
31593AA181 4.5 (0.177)
AT-00142
asieps_tobira.book 74 ページ ２００９年１０月２６日 月曜日 午前９時１６分