Subaru 2006 Legacy, Руководство пользователя

Страница: 3348 / 4302

5AT-45
Differential Side Retainer Oil Seal
AUTOMATIC TRANSMISSION
12.Differential Side Retainer Oil
Seal
A: INSPECTION
Check for leakage of gear oil from differential side
retainer oil seal part. If there is an oil leak, replace
the oil seal.
B: REPLACEMENT
1) Lift-up the vehicle.
2) Remove the front exhaust pipe and center ex-
haust pipe. (Turbo model) <Ref. to EX(H4DOTC)-
6, REMOVAL, Front Exhaust Pipe.> <Ref. to
EX(H4DOTC)-8, REMOVAL, Center Exhaust
Pipe.>
3) Remove the front exhaust pipe. (Non-turbo mod-
el) <Ref. to EX(H6DO)-4, REMOVAL, Front Ex-
haust Pipe.>
4) Remove the differential gear oil drain plug using
TORX
®
BIT T70, and then drain differential gear
oil.
CAUTION:
• Immediately after the vehicle has been run-
ning or after idling for a long time, the differen-
tial gear oil will be hot. Be careful not to burn
yourself.
• Be careful not to spill the differential gear oil
on exhaust pipe to prevent it from emitting
smoke or fire. If differential gear oil is spilled on
the exhaust pipe, wipe it off completely.
5) Tighten the differential gear oil drain plug.
NOTE:
Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb)
6) Separate the front drive shaft from the transmis-
sion. <Ref. to DS-22, REMOVAL, Front Drive
Shaft.>
7) Remove the differential side retainer oil seal us-
ing driver wrapped with vinyl tape etc.
8) Using the ST, install the differential side retainer
oil seal by lightly tapping with a hammer.
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
9) Apply oil to the oil seal lips.
10) Install the front drive shaft. <Ref. to DS-22, IN-
STALLATION, Front Drive Shaft.>
11) Install the front exhaust pipe and the center ex-
haust pipe. (Turbo model) <Ref. to EX(H4DOTC)-
6, INSTALLATION, Front Exhaust Pipe.> <Ref. to
EX(H4DOTC)-9, INSTALLATION, Center Exhaust
Pipe.>
12) Install the front exhaust pipe. (Non-turbo mod-
el) <Ref. to EX(H6DO)-5, INSTALLATION, Front
Exhaust Pipe.>
13) Lower the vehicle.
14) Pour gear oil into the gauge hole.
Recommended gear oil:
<Ref. to 5AT-3, RECOMMENDED GEAR OIL,
SPECIFICATION, General Description.>
Gear oil capacity:
1.3 — 1.5
2
(1.4 — 1.6 US qt, 1.1 — 1.3 Imp qt)
15) Check the level of differential gear oil. <Ref. to
5AT-28, INSPECTION, Differential Gear Oil.>
(A) Oil pan
(B) Differential gear oil drain plug
(B)
AT-01362
(A)
AT-00029
ST
asieps_tobira.book 45 ページ ２００９年１０月２６日 月曜日 午前９時１６分