Subaru 2006 Legacy, Руководство пользователя

Страница: 2325 / 4302

LU(H4DOTC)-24
Engine Oil Filter
LUBRICATION
9. Engine Oil Filter
A: REMOVAL
1) Lift up the vehicle.
2) Remove the under cover.
3) Remove the oil filter using ST.
ST 18332AA000 OIL FILTER WRENCH (Outer
diameter: 68 mm (2.68 in))
ST 18332AA010 OIL FILTER WRENCH (Outer
diameter: 65 mm (2.56 in))
NOTE:
Standard oil filter outer diameter is 68 mm (2.68 in),
however Subaru oil filter with outer diameter of 65
mm (2.56 in) is also available.
B: INSTALLATION
1) Clean the oil filter installation surface on cylinder
block or oil cooler.
2) Obtain a new oil filter and apply a thin coat of en-
gine oil to the seal rubber.
3) Install the oil filter turning it by hand, being care-
ful not to damage the seal rubber.
4) Tighten further after the seal rubber contacts the
oil cooler.
NOTE:
• In case of the filter of outer diameter 68mm (2.68
in), tighten by about one turn. When using a torque
wrench, tighten to 14 N·m (1.4 kgf-m, 10.3 ft-lb).
• In case of the filter of outer diameter 65 mm (2.56
in), tighten by about 2/3 to 3/4 turns. When using a
torque wrench, tighten to 12 N·m (1.2 kgf-m, 8.9 ft-lb).
• Do not tighten excessively, or oil may leak.
5) Install the under cover.
6) Lower the vehicle.
C: INSPECTION
1) After installing the oil filter, run the engine and
make sure that no oil is leaking around seal rubber.
NOTE:
The filter element and filter case are permanently
jointed; therefore, interior cleaning is not neces-
sary.
2) Check the engine oil level. <Ref. to
LU(H4DOTC)-9, INSPECTION, Engine Oil.>
LU-00214
asieps_tobira.book 24 ページ ２００９年１０月２６日 月曜日 午前９時１６分