Stratasys uPrint, Руководство по обслуживанию, Страница: 174 / 383

uPrint/uPrint SE Service Manual 4-127
28.
Place the left side Y belt into the retaining clip.
29.
Slide the translator to the back of the printer.
30.
Using a
5
⁄
16
” box wrench, tighten the right side Y belt clamp mounting screws.
31.
Using a
5
⁄
16
” box wrench, tighten the left side Y belt clamp mounting screws.
32.
Using a
5
⁄
32
” allen wrench, securely fasten the left rear Y guide rod mounting screw.
33.
Reinstall the head board. See Installing the head board on page 4-81.
34.
Reinstall the TC Amp board. See Installing the TC Amp board on page 4-83.
35.
Reinstall the substrate sensor. See Installing the substrate sensor on page 4-66.
36.
Reinstall the toggle head assembly. See Installing the toggle head assembly on page 4-63.
37.
Reinstall the toggle sensor. See Installing the toggle sensor on page 4-70.
38.
Install the 2 XY table alignment brackets to the center of the Y guide rods. See Figure 4-
224.
39.
Adjust the alignment brackets as needed.
40.
Using a
1
⁄
8
” allen wrench, tighten the alignment bracket adjustment screws.
Figure 4-224: XY Table alignment bracket center mounting location
41.
Move 1 alignment bracket to the front of the printer. See Figure 4-225.
42.
Move the translator to the center of the XY table.
43.
Move 1 alignment bracket to the rear of the printer. See Figure 4-225.
Center the
alignment
brackets