Stratasys uPrint, Руководство по обслуживанию, Страница: 110 / 383

uPrint/uPrint SE Service Manual 4-63
Installing the toggle head assembly
1.
Remove the tag from the new toggle head assembly and set aside for later use.
2.
Align the 2 mounting posts with the 2 mounting holes and gently push the toggle head
into position.
3.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the 4 mounting screws.
4.
Reconnect the 3 head motor cables to the back of the head board.
5.
Replace the wire tie holding the head motor cables in place. See Figure 4-106.
Figure 4-106: Wire tie location
6.
Reconnect the toggle sensor cable to the head board.
7.
Gently reconnect the toggle sensor cable to the toggle sensor.
8.
Reconnect the model and support heater cables to the head board.
9.
Reconnect the model and support thermocouples to the TC Amp board.
10.
Place the model and support thermocouple wires in the wire retaining clip.
11.
Connect the model and support material tubes.
12.
Install tips into the heater blocks.
13.
Install tip shields onto the tips.
14.
Reinstall the air plenum
15.
Reinstall the head cover
16.
Reinstall the right side access cover.
17.
Reinstall the side panels. See Installing the side panels on page 4-8.
18.
Reinstall the top panel. See Installing the top panel on page 4-6.
19.
Power the printer up.
20.
Load the MaracaEX.
21.
Click on the + button to add the printer.
22.
Enter the printer name, printer type, printer location and printer IP address.
23.
Click on the green check mark button.
24.
Connect to the printer in MaracaEX by selecting it out of the Current Modeler drop down
menu.
25.
Click on the Tip Offset button.
26.
Enter the value from Z Tip to Tip field on the tag that came with the toggle head
assembly into the Z Tip to Tip field in the Tip Offset window.
27.
Click on the green check mark button.
28.
Cycle power to the printer.
29.
From the display panel press
Maintenance > Machine > Tips
30.
Perform Z calibration.
31.
Perform XY Offset calibration.
Reinstall wire tie
around the head
motor