Stratasys uPrint, Руководство по обслуживанию, Страница: 218 / 383

uPrint/uPrint SE Service Manual 5-9
Figure 5-284: Measuring distance from outside edges of A and B
11.
Next measure and record the distance from the outside edges of circle B and C, see Figure
5-285. Ensure that the caliper is not seated on the small bump of circle C.
Figure 5-285: Measuring distance from outside edges of B and C
12.
Add the lengths derived from steps 10 and 11 (A-B and B-C) and then subtract the width
of circle B. Record this total as “GFront”
13.
Measure and record the distance from the outside edges of circles E and F. Ensure the
caliper is not seated on the small bump of circle E. See Figure 5-286.
Figure 5-286: Measuring distances from outside edges of E and F
14.
Measure and record the distance from the outside edges of circles F and G. Ensure the
caliper is not seated on the small bump of circle G. See Figure 5-287.
Figure 5-287: Measuring distances from outside edges of F and G
15.
Measure and record the diameter of circle F along the center line between E and G. See
Figure 5-288.