Stratasys uPrint, Руководство по обслуживанию, Страница: 278 / 383

uPrint/uPrint SE Service Manual 6-11
Figure 6-384: Holding access space open - model side shown
36.
d.
Ease pressure on the 7/64 T-Handle Allen wrench to carefully return the
leveraged idler wheel back toward its original position - until the idler
assembly is resting against the 1/8 T-Handle Allen wrench.
e.
Remove the 7/64 T-Handle Allen wrench.
C.
Cut the material above the idler wheel using a cutters.
D.
Clean the area that is now accessible using a needle nose pliers, a probe or
equivalent tool.
37.
38.
E.
Reposition the 7/64 T-Handle Allen wrench between the toggle spring post and
the idler wheel post.
F.
Move idler wheel assembly by pushing with 7/64 inch T-Handle Allen wrench
against spring tension and remove the 1/8 T-handled Allen wrench.
G.
Remove the 7/64 T-Handle Allen wrench.
5.
Repeat for the opposite side as needed.
6.
Replace the head cover.
7.
Press
Done
on the display panel.
8.
Display will ask
Which Materials Loaded?
Press
Model
if only model material is loaded,
press
Support
if only support material is loaded or press
Both
if both model and support
material are still loaded. Press
None
if neither are loaded.
9.
Display will ask you to remove the carrier of the materials that are not loaded. Remove
the carrier and cut the excess material.
10.
Press
Done
until back at
Idle
.
11.
Reload the material that is not loaded.
Note: Make sure that all loose material is removed from the affected area.
Note: If the head cover is not replaced the printer may not function properly.
Insert 1/8 inch
T-Handle into
fixture hole.