Stratasys uPrint, Руководство по обслуживанию, Страница: 175 / 383

4-128
Figure 4-225: XY Table alignment bracket mounting locations
44.
Using a
5
⁄
16
” nut driver or standard screwdriver, loosen but do not remove the left side X
guide rod mounting screws.
45.
Center the Y guide rods in the mounting slots and loosely tighten. See Figure 4-226.
Figure 4-226: Center Y guide rods
46.
Slide the translator to the left side of the printer.
47.
Using a
5
⁄
16
” nut driver or standard screwdriver, securely fasten the left side X guide rod
mounting screws.
48.
Slide the translator to the right side of the printer.
49.
Using a
5
⁄
16
” nut driver or standard screwdriver, securely fasten the right side X guide
rod mounting screws.
50.
Raise the Z stage up near the XY table and hold in place using 2 Z guide rod stand off’s.
See Figure 4-227.
Note: Failure to center the Y guide rods before tightening the X guide rod screws will
result in X guide rod misalignment.
Place an alignment
bracket at the front
of the printer
Place an alignment
bracket at the
back of the printer
Position the Y guide rods
so the screw and washer
are in the center