Stratasys uPrint, Руководство по обслуживанию, Страница: 229 / 383

5-20
27.
Add the lengths derived from steps 24 and 25 (A-D and D-G) and then subtract the width
of circle D derived from step 26 . Record this total as “Left Front”
28.
Open MaracaEX and select the Current Modeler from the pull down menu.
29.
Open the
Open Gantry Calibration
Dialog box in MaracaEX.
30.
In the Part Calibration section, there are six boxes: LEFT, RIGHT, FRONT, REAR, LEFT
FRONT and LEFT REAR. Enter the measurements in the appropriate box.
31.
Once the values have been entered, click on the green check mark.
32.
Toggle the system power switch to accept the new values.
33.
Run a test part to verify system is operating correctly.