Stratasys uPrint, Руководство по обслуживанию, Страница: 354 / 383

uPrint/uPrint SE Service Manual 7-11
Figure 7-411: Remove the tips
D.
Repeat for second tip if necessary.
Installing tips
1.
Place the tip shield on the tip. Be sure to install the proper tip. See Figure 7-412.
Figure 7-412: Tip shield alignment
2.
With gloved hand, insert the new tip into the heater block.
3.
Use needle nose pliers to grasp the stainless steel shield of the tip.
4.
Pull the tip shield toward you, then lift up to install the tip.
5.
Push the tip toward the back of the printer once it is all the way up against the heater
block.
Pull tips down to remove
Shorter tube
Imprinted with “T-16
SR30”
Liquefier tubes
Longer tube
Imprinted with “T16”