Stratasys uPrint, Руководство по обслуживанию, Страница: 209 / 383

4-162
37.
Move the dial indicator to the front left of the Z stage and zero the dial indicator.
38.
Using the XY guide rod leveling fixture, adjust the rod up or down until the dial
indicator reads the value the calculator has given. See Figure 4-277.
Figure 4-277: XY guide rod leveling fixture
39.
Using a
5
⁄
32
” allen wrench, securely fasten the front left Y guide rod mounting screw.
40.
Move the dial indicator to the front right of the Z stage and zero the dial indicator.
41.
Using the XY guide rod leveling fixture, adjust the rod up or down until the dial
indicator reads the value the calculator has given.
42.
Using a
5
⁄
32
” allen wrench, securely fasten the front right Y guide rod mounting screw.
43.
Move the dial indicator to the rear right of the Z stage and zero the dial indicator.
44.
Using the XY guide rod leveling fixture, adjust the rod up or down until the dial
indicator reads the value the calculator has given.
45.
Using a
5
⁄
32
” allen wrench, securely fasten the rear right Y guide rod mounting screw.
46.
Repeat steps 32 - 45 until the XY table is completely level.
47.
Remove the XY guide rod alignment brackets.
48.
Remove the XY table leveling bracket and dial indicator.
49.
Reinstall the electronics bay. See Installing the electronics bay on page 4-20.
50.
Reinstall the side panels. See Installing the side panels on page 4-8.
51.
Reinstall the top panel. See Installing the top panel on page 4-6.
52.
Power the printer up.
53.
From the display panel, press
Maintenance > Machine > Tips.
54.
Press Z Calibration to run the automated Z calibration process.