Stratasys uPrint, Руководство по обслуживанию, Страница: 199 / 383

4-152
Installing the Z motor
1.
Place the Z motor in its mounting location and loosely fasten the mounting screws with a
3
⁄
32
” allen wrench.
2.
Insert the leadscrew and turn clockwise until the leadscrew clears the bottom of the
motor.
3.
Raise the Z stage to the upper limit and tighten the leadscrew mounting bracket set
screws.
4.
Lower the Z stage down to its lower limit and tighten the Z stage motor mounting
screws.
5.
Align the Z stage motor energy chain and fasten the mounting screws, be sure not to
overtighten and crush the energy chain.
6.
Attach and tighten the wire ties on both ends of the Z motor wire.
Figure 4-265: Remove the Z motor energy chain
7.
Reinstall the Z stage panel and tighten the 4 mounting screws with a
5
⁄
16
” nut driver or
standard screwdriver.
8.
Reinstall the electronics bay. See Installing the electronics bay on page 4-20.
9.
Reinstall the upper electronics bay cover. See Installing the upper electronics bay cover
on page 4-18.
10.
Reinstall the side panels. See Installing the side panels on page 4-8.
11.
Reinstall the top panel. See Installing the top panel on page 4-6.
Reinstall the
wire tie
Reinstall the
wire tie