Stratasys uPrint, Руководство по обслуживанию, Страница: 222 / 383

uPrint/uPrint SE Service Manual 5-13
24.
Measure and record the distance from the outside edge of the small bump on circle G to
the outside edge of circle D. See Figure 5-295.
Figure 5-295: Measuring distances from outside edges of D and G
25.
Measure and record the diameter of circle D along the center line between A and G. See
Figure 5-296.
Figure 5-296: Measuring diameter of circle D
26.
Add the lengths derived from steps 24 and 25 (A-D and D-G) and then subtract the width
of circle D derived from step 26. Record this total as “GLF”
27.
Enter the Service Calibration menu by pressing the following button sequence on the
display panel:
3,2,3,3,1
. See Figure 5-281.
28.
Press the
Edit Configuration
button.
29.
Press the
GLeft
button. Enter the value recorded from step 18 by pressing the
Increment
,
Decrement
and
Next Digit
buttons.
30.
When finished, press
Done...
31.
Press the
GRight
button. Enter the value recorded from step 17 by pressing the
Increment
,
Decrement
and
Next Digit
buttons.
32.
When finished, press
Done...
Note: The value for GLeft must be between 5.250 and 5.750, the
Done...
button will
not appear until the value is within the acceptable range.