Stratasys uPrint, Руководство по обслуживанию, Страница: 114 / 383

uPrint/uPrint SE Service Manual 4-67
Z Foam Level Assembly
Required Tools
•
3
⁄
32
” allen wrench
Hardware
• 4-40 x
1
⁄
4
” slotted screws and # 4 split lock washer (x4)
Removing the Z Foam Level Assembly
1.
Power down the system using the power-down switch. Once the system is powered
down, switch the circuit breaker to the off position.
2.
Unplug the AC power cord, RJ-45 network cable and UPS cable (if used) from the rear of
the printer.
3.
Remove the top panel. See Top Panel on page 4-5.
4.
Remove the side panels. See Side Panels on page 4-7.
5.
Remove the Substrate sensor. See Substrate Sensor on page 4-64.
6.
Push the Z foam level assembly actuator up into the assembly and slide the Z foam level
bar to the right until it is clear of the assembly. See Figure 4-112.
Figure 4-112: Removing the Z foam level bar