Spectra Logic Spectra nTier700, Руководство по установке

Страница: 42 / 120

Chapter 2 – Installing the nTier700 VTL
42
6. Press the power button on the left side of the front panel. A blue LED indicates that
the power is on, as shown in Figure 2-13.
7.
Wait for the system to complete its power-on sequence. During the power-on
sequence, the nTier700 VTL initializes all of its installed components and starts the
BlueScale web server.
Note:
It can take up to ten minutes for the nTier700 VTL to boot up for
the first time as it automatically starts the operating system, loads
software, and attempts to acquire an IP address.
Note:
The fans in the nTier700 VTL produce a loud, high-pitched whine.
This sound is normal.
Setting the IP Address for Ethernet Port 1
The nTier700 VTL requires a valid IP address for Ethernet port 1 before it can connect
to a network for the first time. By default, the nTier700 VTL uses DHCP addressing to
obtain an IP address for Ethernet port 1. If the nTier700 VTL is connected to an
Ethernet network with a DHCP server, the IP address displays on the operator panel of
each blade. If your network does not use a DHCP server, configure a static (fixed) IP
address for Ethernet port 1 using one of the methods described in this section.
Note:
If you purchased a 10 Gigabit Ethernet card, refer to the
instructions included with the card for configuration instructions.
Figure 2-13 The location of the power button.
Power button