439
[no] offset-list
<access-list-number
|access-list-name> {in|out}
<number > [<ifname>]
Configure that provide a deviation value to the
route metric value when the port sends or
receives RIPng data packet; the
[no]
offset-list<access-list-number
|access-list-name> {in|out} <number >
[<ifname>]
command removes the deviation
table
3
）
configure and apply route filter and route aggregation
Command Explanation
Router configuration mode
[no] distribute-list {<
access-list-number
|access-list-name > |
prefix<prefix-list-name>} {in|out}
[<ifname>]
Set to filter the route when the interface
sends and receives RIPng data packets.
The
[no] distribute-list {<
access-list-number |access-list-name > |
prefix<prefix-list-name>} {in|out}
[<ifname>]
command means do not set the
route filter
[no]aggregate-address
<IPv6-address>
Configure route aggregation, the
[no]aggregate-address
<IPv6-address>
command cancels the route aggregation.
4
）
configure split horizon
Command Explanation
Interface configuration mode
IPv6 rip split-horizon [poisoned]
Configure that take the split-horizon when the
port sends data packets, poisoned means
with poison reverse
no IPv6 rip split-horizon
Cancel the split-horizon.
(3) Configure other RIPng protocol parameters
1
）
Configure timer for RIPng update, timeout and hold-down
Command Explanation
Router configuration mode
timers basic <update> <invalid>
<garbage>
no timers basic
Adjust the renew, timeout and garbage
recycle RIPng timer, the no timers basic
command restore the default configuration
