443
Usage Guide:
The command can configure on IPv6 tunnel interface, but it is successful
configuration to only configure tunnel carefully.
Example:
Switch# config terminal
Switch(config)# interface Vlan1
Switch(config-if-Vlan1)# ipv6 router rip
14.5.3.8 neighbor
Command: [no] neighbor <ipv6-address> <ifname>
Function:
Specify the destination address for fixed sending. The “
[no] neighbor
<ipv6-address> <ifname>
“ cancels the specified address defined and restores all
trusted gateways
Parameter: <ipv6-address>
is the IPv6 Link-local address specified for sending and
shown in colon hex notation without the prefix length.
<ifname>
is the name of interface.
Default:
Not sending to any fixed destination address
Command Mode:
Router mode
Usage Guide:
When used associating passive-interface command it would be able to
send routing messages to specified neighbor only.
Example:
Switch# config terminal
Switch(config)# router ipv6 rip
Switch(config-router)# neighbor FE80:506::2 Vlan1
14.5.3.9 Offset-list
Command: [no] offset-list <access-list-number
|access-list-name> {in|out }<number >[<ifname>]
Function:
Add an offset value on the routing metric value learnt by RIPng. The
“
|access-list-name> {in|out }<number >[<ifname>]
” command disables this function
Parameter: < access-list-number |access-list-name>
is the access-list or name to be
applied.
<number >
is the additional offset value, ranging between 0-16;
<ifname>
is the
name of specific interface
Default: The default offset value is the metric value of the interface defined by the
system./
Command Mode:
Router mode
Example:
Switch# config terminal
Switch(config)# router ipv6 rip
Switch(config-router)# offset-list 1 in 5 Vlan1
