834
Command
：
control-vlan <VID>
no control-vlan
Function
：
Configure control VLAN ID of MRPP ring; the
“
no control-vlan
”
command
deletes control VLAN ID.
Parameter
：
<VID>
expresses control VLAN ID, the valid range is from 1 to 4094.
Command Mode
：
MRPP ring mode
Default
：
None
Usage Guide
：
The command specifies Virtual VLAN ID of MRPP ring, currently it can
be any value in 1-4094.To avoid confusion, it is recommended that the ID is
non-configured VLAN ID, and the same to MRPP ring ID. In configuration of MRPP ring
of the same MRPP loop switches, the control VLAN ID must be the same, otherwise the
whole MRPP loop may can’t work normally or form broadcast.
Example
：
Configure control VLAN of mrpp ring 4000 is 4000.
Switch(Config)# mrpp ring 4000
Switch(mrpp-ring-4000)#control-vlan 4000
22.3.3 debug mrpp
Command :debug mrpp
no debug mrpp
Function
：
Open MRPP debug information;
“
no description
”
command disables MRPP
debug inforamation
Command Mode
：
Admin Mode
Parameter
：
None
Usage Guide
：
Enable MRPP debug information, and check message process of MRPP
protocol and receive data package process, it is helpful to monitor debug.
Example
：
Enable debug information of MRPP protocol.
Switch#debug mrpp
22.3.4 enable
Command
：
enable
no enable
Function
：
Enable configured MRPP ring, the
“
no enable
”
command disables this
enabled MRPP ring.
Parameter
：
Command Mode
：
MRPP ring mode
Default
：
Default disable MRPP ring.
