445
Parameter:
Specifies this destination IPv6 address prefix and its length show in
colon hex notation.
Usage Guide:
The command add a static RIPng route, and is mainly used for debugging.
Routes configured by this command will not appear in kernel route table but in the RIPng
route database, however it could be located by using the show ipv6 rip command.
Command Mode:
Router mode
Example:
Switch# config terminal
Switch(config)# router ipv6 rip
Switch(config-router)# route 3ffe:1234:5678::1/64
14.5.3.13 router ipv6 rip
Command: router ipv6 rip
no router ipv6 rip
Function:
Enable RIPng routing process and entering RIPng mode; the “
no router ipv6
rip
” of this command disables the RIPng routing protocol.
Default:
RIPng routing not running
Command Mode:
Global mode
Usage Guide:
This command is for enabling the RIPng routing protocol, this command
should be enabled before performing other global configuration of the RIPng protocol.
Example:
Enable the RIPng protocol mode
Switch(Config)#router ipv6 rip
Switch(Config-Router)#
14.5.4 RIPng Configuration Examples
Fig 14-5 RIPng Example
As shown in the above figure, a network consists of three layer 3 switches. SwitchA and
