Sequoia LISST-200X, Руководство пользователя

Страница: 100 / 112

Appendix G: LISST-Black & LISST-HAB 92 LISST-
200X User’s Manual
4. Rotate the Mid Support as needed to make the axis of the sensors parallel to the axis
of the LISST-200X. Tighten the Mid Support clamp making sure that the Mid Support
is pushed against the tapered part of the pressure case, as in step 2. The sensors
should be free to rotate and move forward and backward.
5. Attach the Cable Support onto the LISST-200X. Tighten the Cable Support clamping
screw slightly so that the Cable Support is held in place but free to rotate and slide
along the case.
6. If the LISST-HAB/Black will be used with the LISST-200X Frame , place the Frame
Clamp between the sensors and the LISST-200X pressure case before connecting
the LISST-HAB/Black cable. Installing the Frame Clamp after assembly is difficult
and not recommended.
7. Attach the LISST-HAB/Black cable to the sensors.
a. The protrusion in the mold needs to be on the top side.
b. Rotate the sensors to match the cable sockets and insert into the connector.
c. Secure the cable locking sleeves.
d. Slide the Cable Support towards the optics end so that cables are supported.
Do not tighten the clamp yet.
8.
Position the sensors so they extend approximately 1/8” (3mm) in front of the Front
Support. Secure the sensors with the Hold-down Set Screws.
9. Place the Cover onto the assembly and adjust the position of the Cable Support so
that the Cover can be easily installed. Insert the Cover Screws into the holes at the
Front Support. Adjust the Cable Support position as need so that the holes in the
Cover line up with the holes in the Cable Support and secure it with the Cover
screws. Tighten the Cover and Cable Support clamp screws.
10. Connect the cable to the 6-pin connector on the LISST-200X.
11. Secure the cable to the handle with cable ties.