Sequoia LISST-200X, Руководство пользователя

Страница: 103 / 112

LISST-
200X User’s Manual
95 Appendix H: BioBlock Anti-fouling Wiper
3. Insert the motor assembly C into bracket A and then B, until the end of the motor is
flush with the bracket A (not protruding, as shown in the picture; the position will be
adjusted later). Rotate the motor assembly so the rotor arm is pointing up. Lightly
tighten all the bracket screws.
4. Insert the plastic insert D from the top until the tabs on the bottom click in place in the
optics head.
5. Insert the wiper assembly E from the bottom. The arm attached to the wiper will tend
to catch on the optics head. Rotate the 200X to keep the arm centered while ‘pushing
up’ on the wiper assembly.
6.
{9/64” and 1/16” Allen wrench} Remove the front screw on the rotor (at F) and one
plastic washer. Loosen the Large and Small Bracket screws. Push the motor
assembly forward to align the rotor to the arm. Slide the arm onto the pin and
reattach the washer and screw. When tightening the screw, hold the motor arm
stationary, to prevent forced rotation of the motor. Slide the motor so its endcap seam
is aligned with the front face of the large bracket. Align the small bracket (B) so the
motor assembly is parallel to the 200X body. Tighten the large and small bracket
screws that clamp them to the 200X body. Rotate the motor assembly until the arm is
pointing straight up. Tighten the screws on the brackets A and B.
Final adjustment and test
a. Connect the Bio-Block to the 200X
endcap with the 20” long cable. Use a cable tie
or tape to secure the cable on the 200X handle.
b. Power up the 200X and connect to it with LISST-200X software. Open the
terminal window.
c. In the terminal window, type BB OPEN and BB CLOSE several times to make
sure the copper parts do not rub against the windows or any part of the optics
endcap. Finish with BB OPEN command.
d.
{9/64” Allen wrench} If the Bio-Block wipers are not in the raised position, loosen
the clamps around the motor assembly and adjust them until the wipers are up.
e. Test the BB CLOSE and BB OPEN commands again.