Sequoia LISST-200X, Руководство пользователя

Страница: 99 / 112

LISST-
200X User’s Manual
91 Appendix G: LISST-Black & LISST-HAB
LISST-Black/LISST-HAB Mounting instructions
Hardware:
Clamp Screws, 8-
32 x ½” Socket Head Cap Screws, 316 Stainless Steel
Sensor Hold-down Set Screws, 8-
32 x 3/16” Set Screws, flat tip, 316 Stainless Steel
Cover Screws, 6-
32 x ¼” Flat Head Phillips Screws, 316 Stainless Steel
Tools:
5/64-inch hex L-key
9/64-inch hex L-key
#2 Phillips Screwdriver
1. Attach the Front Support to the LISST-200X with the Clamp Strap, cross nut and
clamping screw. Position the tab on the Front Support so it fits flush against the
endcap and aligns to the flat surface. Tighten the Clamp Screw.
2. Position the Mid Support on the LISST-200X so
the back edge is positioned on the pressure case
chamfer, as shown at right, and the holes for the
fluorometers line up with the Front Support.
Slightly tighten the Mid Support clamping screw so
that the Mid Support is held in place but can be
rotated as needed when inserting the sensors.
3. Insert all three Cyclops-7F Sensors. Note the
order of the sensors. The labels shown in the figure correspond to their labels in the
data file (see Appendix C: Data File Formats). When looking at the connector end of
the sensors, sensor 1 will be on the left and sensor 3 will be on the right. Do not
tighten the setscrews holding the sensors yet.