Schweitzer Engineering Laboratories SEL-700G Series, Инструкция по эксплуатации

Страница: 817 / 824

Date Code 20170814 Instruction Manual SEL-700G Relay
SEL-700G Relay Command Summary
Instruction Manual
The table below lists the front serial port ASCII commands associated with particular activities. The commands
are shown in uppercase letters, but they can also be entered using lowercase letters.
Serial Port Command Command Description
Access Level 0 Commands
ACC Goes to Access Level 1.
ID Relay identification code.
QUI Goes to Access Level 0.
Access Level 1 Commands
2AC Goes to Access Level 2.
BRE n Displays breaker n monitor data (trips, interrupted current, wear). Select n = X or n = Y for Breaker X or
Breaker Y data.
CEV n Shows compressed event report number n, at 1/4-cycle resolution. Attach R for compressed raw report, at
1/32-cycle resolution.
CGSR n Shows compressed generator synchronizing report n, where n =1 to 7 (defaults to 1).
COM A Returns a summary report of the last 255 records in the communications buffer for M
IRRORED
B
ITS
communications Channel A.
COM B Returns a summary report of the last 255 records in the communications buffer for M
IRRORED
B
ITS
communications Channel B.
COM C Clears all communications records. If both M
IRRORED
B
ITS
channels are enabled, omitting the channel
specifier (A or B) clears both channels.
COM C A Clears all communications records for Channel A.
COM C B Clears all communications records for Channel B.
COM L Appends a long report to the summary report of the last 255 records in the M
IRRORED
B
ITS
communications buffer.
COM L A Appends a long report to the summary report of the last 255 records in the communications buffer for
M
IRRORED
B
ITS
communications Channel A.
COM L B Appends a long report to the summary report of the last 255 records in the communications buffer for
M
IRRORED
B
ITS
communications Channel B.
COM S Returns a summary report of the last 255 records in the M
IRRORED
B
ITS
communications buffer.
COU n Shows current state of device counters. n = repeat the report n times, with a 1/2 second delay between each
report.
DAT Views the date.
DAT dd/mm/yyyy Enters date in DMY format.
DAT mm/dd/yyyy Enters date in MDY format if DATE_F setting is MDY.
DAT yyyy/mm/dd Enters date in YMD format if DATE_F setting is YMD.
ETH Shows the Ethernet port status.
EVE n Shows event report n with 4 samples per cycle. If n is omitted, most recent report is displayed.
EVE R n Shows event report n with raw (unfiltered) 32 samples per cycle analog data and 4 samples per cycle
digital data.
FIL DIR Returns a list of files.