schmersal bp408, Руководство по установке

Страница: 91 / 122

Installation manual of system “bp408” - Commissioning 91
8.4 Connecting the mains voltage
If you have answered "Yes" to every question in the "Checklist before switching on
the control system", you can switch on the mains voltage. Subsequently check the
items in the following checklist.
Is the main switch switched on?
Yes
□
Is the return control switched on?
Yes
□
Is the automatic circuit breaker for the control voltage switched on?
Yes
□
Is the circuit breaker for the safety circuit switched on?
Yes
□
Has no protective device been triggered?
Yes
□
Doesn’t the STM-02 voltage test module give an audible or visual warning signal?
Yes
□
Does the LCD display on the bp408 system module report any voltage problems?
Yes
□
Is the voltage at the power supply between terminals L and N 230 V AC?
Yes
□
Is the voltage at the power supply in the control cabinet te24 compared to terminal
0 equal to 24 V DC? Are the car operating panel and CLK supplied with 24 V? Yes
□
The LCD light is not flashing? (System would be blocked.)
Yes
□
Is the colon of time on the LCD of the bp408 flashing?
Yes
□
Is car light voltage at the X92.LN and X92.3 = 230 V AC?
Yes
□
Do the LED(s) for 5 V and 24 V operating display glow, on the external power supply, if
available? Yes
□
Is the RHS symbol displayed on the display of the bp408 (return control active)?
Yes
□
If you have answered all questions with »Yes«, then you can proceed with checking
the parameters of the control system and of the drive.