schmersal bp408, Руководство по установке

Страница: 73 / 122

Installation manual of system “bp408” - Electrical connection 73
7.7.6 Node numbers of CAN components
Each CANopen Lift component has a node number (Node-ID) for identification. It
must be unique within a CANopen Lift network. If there are two components with
the same ID on the bus, these assmblies cannot be approached.
At Böhnke + Partner GmbH, the node numbers (Node-ID) are issued according to
the recommendation of the SIG-Lift Control (www.CANopen-Lift.org/wiki/Node-IDs)
according to the following scheme:
If you obtain the control system from Böhnke + Partner GmbH, all node numbers
(Node-IDs) are already set by default.
7.8 Flat travelling line to car terminal box
The cabin terminal box is connected via a H05VEA7VH6-F flat travelling line. The
assignment of the wires can be found in the circuit diagrams enclosed with the
control system.
Node-ID
[decimal]
CAN1
Local bus
CAN2
Shaft bus
1 bp408 - lift control system bp408 – lift control system G1
2 Drive (frequency converter) bp408 – lift control system G2
3 reserved bp408 – lift control system G3
4 Transmitter/positioning 1 bp408 – lift control system G4
5 Transmitter/positioning 2 bp408 – lift control system G5
6 reserved bp408 – lift control system G6
7 Door control system 1 (door A) bp408 – lift control system G7
8 Door control system 2 (door B) bp408 – lift control system G8
9 Door control system 3 (door C) CDG-01 /CSI-01 – Bridge / Repeater
10 CDG-01 - Gateway / CSI-01 - Bridge Bridge / Repeater 2
11 CIO-01 in control cabinet Bridge / Repeater 3
12 Inspection box with CLK-03 Bridge / Repeater 4
13 Load measurement Bridge / Repeater 5
14 Energy meter Bridge / Repeater 6
15 reserved Bridge / Repeater 7
16 CAP-02 / CBK-01 inner tableau node 1 Bridge / Repeater 8
17-20 CAP-02 / CBK-01 inner tableau nodes 2 - 5
21-84 CAP-02 / CBK-01 / CIO-01 in shaft
111-118 CAP-02 / CIO-01 in control cabinet
119 CWI-01
125
Default Node-ID (default setting of a bearing component such as wie CAP-02, CBK-01 or
CIO-01)
126 Flash update of bootloader
127 CANWizard