schmersal bp408, Руководство по установке, Страница: 106 / 122

106 Installation manual of system “bp408” - Commissioning
Now, drive to every floor from both directions of travel and check whether the lift
does a levelled drive-in. For this, use the levelling test under
DIAGNOSIS > SHAFT SIGNALS > LEVELLING TEST
.
If the lift does not stop at the previously set
position, the
BRAKING DISTANCE V0 (STOPPING DISTANCE)
can be adjusted under
FUNCTIONS > DRIVE
.
The sensitivity of the readjustment range can
be set independent of the levelling range.
Refer to service menu:
TIMES > DRIVE / READJUST DECELERATION
TIME
8.11.4 Drive speeds
The drive speeds are set in the service menu in the menu option
SETTING> FUNCTIONS > DRIVE
.
Abbreviation for the name of the speed:
VN = Readjusted speed
VI = Inspection speed
VR = Return speed
V0 = Drive-in speed
V1..V7 Intermediate speeds and fast speed, depending on the set drive type.
In case of a change in the drive speeds, a calculation of the braking and minimum
drive distances will be offered. These must be adjusted, if necessary.
NOTE!
V0 < V1 < V2 < V3 < V4 < V5 < V6 < V7!
Figure 66:
Levelling test
Figure 67:
Drive curve in the example of a DCP3 connection with V4 as nominal speed