schmersal bp408, Руководство по установке

Страница: 41 / 122

Installation manual of system “bp408” - The control system “bp408” 41
5.7.7 Information menu
The information menu enables you to toggle
between two menu options with a click. Thus, you
can change parameters at a point in the service
menu and with a click view the response in the
system, e.g. travel signals.
In order to toggle in the information menu, click on
the Info/Set key once. If the information menu is
active, it is signalled with an “i” in the lift status bar.
Now you can navigate through the menu. With
another click, you are again at the menu point,
where you had activated the information menu.
You can now toggle between the two menus with
a single click.
5.7.8 Terminal mode
The following procedure has been specified in the application profile CANopen Lift
(CiA 417): An assembly that is connected to the CAN-Bus sends the content of the
display to another device via bus. It represents the content.
In this way, it is possible to navigate through the menu of the external device.
This procedure was integrated in the control system bp408 and is available in the
menu under node list and in the terminal mode specially for the frequency converter.
It is possible to toggle to the terminal mode by
simultaneously pressing the keys Info/Set and “Right”
and the menu of the frequency converter connected is
displayed on the display of bp408. The signals of the
navigation keys “Up”, “Down”, “Left”, “Right”, “OK” and
“INFO/SET” are now sent to the frequency converter. By
pressing the “Call/End” key for minimum 3 seconds, the
terminal mode is ended and the last menu point of bp408
can be seen again.
Figure 32:
You can switch over to the
terminal
mode by
simultaneously pressing the
keys Info/Set and Right.
Figure 31:
Menu change