schmersal bp408, Руководство по установке

Страница: 105 / 122

Installation manual of system “bp408” - Commissioning 105
8.11.3 Setting drive with the absolute encoder
After these settings have been carried out, the setting drive can be begun, taking
into consideration the following instructions. In the setting drive, the exact levelling
positions of all floors are determined and stored in the programming memory.
Please proceed as follows:
1. Switch the system to RETURN OPERATION.
2. Using the return control, take the lift to the lowest stop
(Floor 1) as close to the levelling position as possible. You can reach the exact
levelling position with the cable elevator by releasing the brake and rotating
the handwheel.
3. In case of the hydraulic lift, you must set the levelling position by pressing the
emergency release valve or the hand pump.
4. If the lift stands levelled on floor 1, either press the >>OK<< key on the LC
display or the car call key of Floor 1.
For checking purposes, the correct reading of the levelling position is signalled
by 1 through the acknowledgement lamp.
5. Proceed similarly for the remaining floors.
6. Switch off the return operation.
7. Subsequently, drive to every floor and check the levelling positions. Make a
note of the deviations.
8. Enter the corrections on the control system using the control panel.
9. Once all levelling positions are checked and corrected, the normal operation
can be switched back again.
Figure 65:
Setting ranges