schmersal bp408, Руководство по установке

Страница: 114 / 122

114 Installation manual of system “bp408” - Troubleshooting
9.2 Fault information
Disturbances influence the sequence of functions in the lift control system in such
a way that proper operation is not possible. All current events that have led to a
fault of the lift functions are displayed, e.g.

Speed limiter has been activated
 PTC resistor in the drive motor, PTC resistor in the hydraulic unit,
 start control, drive control, deceleration control,
 brake control, contactor control,

copying error,
 inverter fault,
 door-locking/opening control,
 Safety circuit.
If a fault occurs, it is recorded in the fault stack and the fault list. If the system is
connected to a WinMOS®300remote diagnostics system, a callback can be
triggered when a fault occurs. All fault information can also be transmitted with
Lift2CLOUD.
Critical errors can lead to a locking of the system. The lock can be aborted after
the cause has been eliminated. The abortion can be activated by pressing the
»Call/End« button and responding to the instruction with the »OK« button or by
momentarily switching off the operating voltage.
Very serious faults cannot be reset by switching off the operating voltage.
Non-serious errors such as door-locking errors can be reset via a new call.
9.3 Report faults
All bp408 are prepared for the remote diagnosis. To connect the control system to
an intranet or the Internet, the bp408 control system is equipped with a LAN
connection. If the connection is made via the telephone network, a modem can be
connected to the USB-A interface. Gateways for the LONmark standard, OPC
server, Profibus, Modbus and BACnet are available for the connection to the
building automation.
If the fault recall is activated in the setup menu, it will be transmitted along with the
type, date and time to the set service centre after a fault has occurred.
More detailed information on the remote diagnosis can be found in the WinOS®300
manual or under
www.WinMOS.de .