Sabio 2010D, Руководство по эксплуатации

Страница: 123 / 182

Serial Communications Page 7-21
_________________________________________________________________
70 Seq Start Error An error occurred attempting to
start the seq.
71 Bad Seq Name The sequence name is invalid.
72 Bad Seq Point Invalid point number.
73 No Active Seq No sequence is active.
Stop (S)
The Stop command terminates any calibrations in progress and
places the calibrator in a quiescent, idle state.
Command Format
Command
@ S , {AAA} [CHK]<CR>
Response
Good: <ACK>
Error: <NAK>[ER][<CR>]
Purge (P)
The Purge command causes the calibrator to purge its source
inlet manifold for a short duration.
The default duration is
five seconds, but can be changed in the
2010D '
s dilution
parameters setup screen. If a source valve is active when the
purge command is sent, the
2010D
will purge calibration gas
through the manifold; otherwise, the gas manifold will simply be
opened to atmosphere for the purge duration.
Command Format
Command
@ P , {AAA} [CHK]<CR>
Response
Good: <ACK>
Error: <NAK>[ER][<CR>]