Ruijie Networks RG-S2600E Series, Справочное руководство CLI

Страница: 347 / 1191

S2600E CLI Reference Guide Chapter 1 SNMP Configuration Command
snmp-server
queue-length
Specify the length of the SNMP trap
message queue.
snmp-server
host
Specify the NMS host to send the
SNMP trap message.
1.1.14 snmp-server user
Use this command to set the SNMP name in the global configuration mode . The
no form of this command is used to delete the user.
snmp-server user username groupname { v1 | v2c | v3 [ encrypted ] [ auth
{ md5 | sha } auth-password ] [ priv des56 priv-password ]} [ access {[ipv6
ipv6_aclname ][acl num | acl name }] ]
no snmp-server user username groupname { v1 | v2c | v3 }
Parameter Description
username User name
groupname Group name of the user.
v1 | v2c | v3
SNMP version. But only SNMPv3
supports the following security
parameters.
encrypted
Input the password in cipher text mode.
In cipher text mode, input continuous
HEX alphanumeric characters. Note that
the authentication password of MD5 has
a length of 16 characters, while that of
SHA has a length of 20 bytes. Two
characters make a byte. The encrypted
key can only be used by the local SNMP
engine on the switch.
auth
Specify whether to use the
authentication.
auth-password
Password string (no more than 32
characters) used by the authentication
protocol. The system will change the
password to the corresponding
authentication key.
Parameter
description
priv
Encryption mode. des56 refers to 56-bit
DES encryption protocol.
priv-password : password string (no more
than 32 characters) used for encryption.
The system will change the password to
the corresponding encryption key.