Rohde & Schwarz 1424.7805K02, Руководство пользователя

Страница: 146 / 530

System settings
R&S
®
NRX
146 User Manual 1178.5566.02 ─ 09
└ Measurement for Recorder Output ............................................................... 149
└ 0 V Equivalent ...............................................................................................149
└ 2.5 V Equivalent ............................................................................................149
└ Measurement for Limit Output ...................................................................... 150
└ Fail Voltage ................................................................................................... 150
└ Trigger Source for Trigger Output ................................................................. 150
└ Impedance for Trigger Input ..........................................................................150
Sensor Check Source tab
Requires the sensor check source (R&S NRX-B1). If the option is installed, this tab is
displayed as first tab.
Configures the sensor check source (R&S NRX-B1) that is installed in the module bay.
See
"Sensor check source (R&S NRX-B1)" on page 26.
Figure 10-2: Sensor Check Source tab
In the upper pane, the result display shows the effect of parameter changes on the
measurement.
Signal Output ← Sensor Check Source tab
Disables the output or sets the signal type, continuous wave or pulses.
Remote command:
SOURce:OUTPut:STATe
OUTPut:SOURce:STATe
SOURce:PULM:STATe
Frequency ← Sensor Check Source tab
Sets the frequency of the output signal.
Remote command:
SOURce[:RF]:FREQuency[:VALue]
Connections