Resvent iHope RS Series, Руководство пользователя

Страница: 51 / 261

3-13
3. Installations and Connections
•
To reduce the risk of hypoxia, connect only oxygen
to the high-pressure connector at the rear of the
ventilator.
CAUTION
•
To prevent possible damage to the ventilator,
ensure that the connection to the oxygen supply is
clean and unlubricated, and that there is no water
in the oxygen supply gas.
•
The ventilator’s oxygen control is not active when
low-pressure oxygen is used. To prevent possible
patient injury, use low-pressure oxygen only in
cases where the low-pressure supply can provide
an adequate level of oxygenation.
•
To prevent possible patient injury, make sure that
an emergency backup O
2
supply (for example, a
gas cylinder) is available in case the low-pressure
O
2
supply fails.
•
Do not connect the ventilator to both high
pressure and low pressure oxygen supply.
Oxygen for the ventilator can come from a high- or
low-pressure source.
When the high pressure oxygen supply is connected,
the normal pressure of the gas source is 280~600kPa.
If the gas supply pressure is less than 280kPa, it will
compromise the performance of the ventilator and
even stop the ventilation.
When the low-pressure oxygen supply is connected,
the supply of low-pressure oxygen does not exceed
15L/min. To reduce the risk of fire, do not use a low-
pressure oxygen supply that delivers a flow rate of more
than 15L/min.