Resvent iHope RS Series, Руководство пользователя

Страница: 178 / 261

9-10
9. Maintenance
9.3.5 Battery Recycling
If obvious signs of damage are detected on the battery
or the battery recharging has failed, replace the battery
and recycle it properly. Dispose of the battery in
compliance with the local laws regulating the disposal
of such product.
WARNING
•
Do not disassemble batteries, or dispose of them
in fire, or short-circuit them. They may ignite,
explode and leak, causing personal injury.
9.4 Pressure and Flow Zeroing
Zero pressure and flow when the monitored pressure
or flow value has a great deviation. Zeroing can be
performed in standby mode only.
Follow these steps to zero pressure and flow:
1. Open the [
Setup]
->[
Sensor]
->[
Zeroing]
->
[
Paw&Flow]
window to access the pressure and
flow zeroing, then press [
Start ]
to begin the zeroing.
2. If the zeroing failed, you need to do the zeroing
again.
9.5 Flow Calibration
NOTE
• Make sure another source of ventilatory support is
available during this calibration. The patient must
be disconnected from the ventilator during it.
• Do not perform flow calibration when low-pressure
oxygen source is used.
• During calibration, do not operate the pneumatic
parts. Do not move or press the breathing tubes
especially.
• Make sure that the system is Standby mode.