Instruction manual
Page 75 / 189
Copyright © REA Elektronik
REA JET HR
pro
2K / 4K
V 3.5x_001 28.05.2015
5
-- Quick flashing --
Step 4:
The parameter display (red) then starts to flash quickly
again, which indicates that the teach-in process for the
background is starting.
6
Step 5:
Position the background beneath the sensor.
7
--- 0.5 seconds on ---
Step 6:
Press the Teach button for about 0.5 seconds
The parameter display (red) is lit approx. 0.5 seconds,
which indicates that the teach-in process for the
background is completed.
8
Step 7:
When the teach-in has been completed successfully,
the red teach-in LED turns off and the green operating
display is lit.
9
Step 8:
If the teach-in process has failed, this is show by a
slowly flashing LED (flashing in intervals of approx. 6
seconds).
In this case, teach-in programming has to be repeated
from step 1.
If this sensor is not connected to the sensor connection
of the REA JET HR print head, please ensure that
under no circumstances connection 2 (pink) of this
sensor is activated. This is done via remote
parameterization.
Figure 70: Setting instructions for the opto-electric product sensor type 3
