Instruction manual
Page 67 / 189
Copyright © REA Elektronik
REA JET HR
pro
2K / 4K
V 3.5x_001 28.05.2015
No.
View / Functional element
Description / Step
10
Step 9:
The optimum setting for sensitivity is between the two
points determined in steps 5 and 7.
Now turn the controller for sensitivity to the average
value (point III) between the bookmarked points I and
II. (This normally corresponds to the optimum
sensitivity.)
The orange LED must be off and the green LED must
still be lit. If one of these two preconditions is not
fulfilled, repeat steps 2 to 9.
11
Step 10:
Position the product to be detected in front of the
sensor again, just like it will be guided along the
stripper plate of the print head later.
If the orange output display is lit and the green display
continues to be lit, the setting is done. If these
conditions are not met, please repeat steps 2 to 10.
12
Note:
Compliance with the following points is important for
the proper functionality of the sensor.
Free opening for the sensor in the stripper
plate (free from product residues and
contamination of kinds).
Undamaged anodized layer for the sensor in
the stripping plate.
No excessive foreign light influence on the
sensor (e.g. as a result of camera lighting).
Settings must be made with caution.
If despite observance of these points no satisfying
settings can be made to the sensor, the sensor might
not be suitable for detecting the product. Please use a
different sensor.
Figure 65: Setting instructions for the opto-electrical product sensor type 1
Point: III
