Raytheon Anschütz NautoPilot 5000 Series, Руководство оператора

Страница: 138 / 191

NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
10000001052
122
Edition: 003
4.5.2 Preconditions for switching to Track Control mode
Table 31 Checks to be made before switching to Track Control with RAYTHEON Anschütz ECDIS
Check Comment
Heading source
The desired heading source is shown above the actual
heading value.
The source is supposed to be the same as displayed at
the ECDIS.
The heading source can be adjusted via the Page
function: Softkeys Page
→
Value
→
Heading
(see also section 2.3.6.1 and Figure 44).
Gyro or GPS must be selected. It is not possible to use
magnetic heading.
Heading value The heading value must be valid.
- Check actual heading, as this will be the
set Course over Ground after switching to
Course Control.
The value is supposed to be the same as displayed at the
ECDIS.
Speed source The desired speed source is shown and can be adjusted
via the Page function:
Softkeys Page
→
Value
→
Speed
(see also section 2.3.6.2 and Figure 50)
Speed value The speed value must be valid.
If speed value is invalid, select Manual Speed.
(see also section 2.3.6.2 and Figure 50)
Position source If only one position sensor is available, and no speed
source is available, it is not possible to activate Course
Control (see also section 2.3.5.5).
Position value The position value must be valid.
If no position sensor is available, it is not possible to
activate Course Control (see also section 2.3.5.5).