OPERATION OF MULTIRAE PLUS
2 - 14
8) The
run time
reading is the accumulated “On” time in
hours and minutes since the monitor was turned on. The
reading is updated at one minute intervals and is shown
in the LCD display together with the current date, time
and temperature.
TOX1
VOC
TOX2
8/3/96
8:30
On = 3:50 20
°
C
LEL
OXY
9) The
datalog
menu shows the current datalog mode. If
manual datalog mode is selected, the menu will prompt
the user to turn on or off datalogging. Pressing the
[Y/+]
key while “Start Datalog?” message is displayed turns on
the datalogging. Likewise, pressing the
[Y/+]
key while
“Stop Datalog?” message is displayed turns off the
datalogging.
10) The monitor will display the selected
LEL
and
VOC gas
name
if the combustible sensor and PID sensor are
installed. When an LEL or VOC gas is selected, the
“calculated” gas concentration based on the built-in
correction factor for that specific gas will be displayed.
11)
Print Reading?
asks for printing out of the gas
concentration reading. If a serial printer is connected
and ready, pressing the
[Y/+]
key will print out the
reading.
Содержание MultiRAE PLUS PGM-50
Страница 165: ...APPENDIX A A 2 Change LEL VOC Gas Selection Enable Disable Sensor Change Dilution Ratio Change PID Lamp Type N Y Mode N...
Страница 169: ...APPENDIX B B 4 sensitivity to the gas is higher than that of isobutylene VOC or methane LEL...
Страница 176: ...APPENDIX C C 7...
Страница 183: ...APPENDIX G G 2 RAE Systems Service Department...
