PROGRAMMING OF MULTIRAE
4 - 31
4.7.2 Change Alarm Mode
There are two different alarm modes:
latched
and
automatic reset
in
MultiRAE PLUS
that can be selected
from the programming menu.
1. “Change Alarm Mode?” is the third sub-menu item in
Table 4.6.
2. Press the
[Y/+]
key, the display shows the current alarm
mode selection: “Alarm Mode = Latched?”
3. Press the
[Y/+]
key to accept the currently displayed
alarm mode. Press
[N/-]
key to change to the other
alarm mode: “Alarm Mode = Auto Reset?” Press
[MODE]
key to exit this sub-menu and move to the next
monitor setup sub-menu.
4. If there is any change to the existing selection, pressing
the
[y/+]
key the display will show “Save?” Then, press
the
[Y/+]
key to accept or the
[N/-]
key to discard and
move to the next sub-menu.
Содержание MultiRAE PLUS PGM-50
Страница 165: ...APPENDIX A A 2 Change LEL VOC Gas Selection Enable Disable Sensor Change Dilution Ratio Change PID Lamp Type N Y Mode N...
Страница 169: ...APPENDIX B B 4 sensitivity to the gas is higher than that of isobutylene VOC or methane LEL...
Страница 176: ...APPENDIX C C 7...
Страница 183: ...APPENDIX G G 2 RAE Systems Service Department...
