OPERATION OF MULTIRAE PLUS
2 - 25
Start/stop datalogging manually
If manual datalogging mode has been selected from the
normal operation menu, toggle through the menu using the
[MODE]
key until the
Start Datalog?
prompt is displayed.
Pressing the
[Y/+]
key turns on datalogging. Likewise,
pressing the
[Y/+]
key while
Stop Datalog?
is displayed,
turns off datalogging.
The other three datalogging options will start and stop
automatically without any user intervention:
Datalogging event
Each time a datalogging operation is initiated, a datalog
event is created. Information, such as start time, datalogging
period, alarm limits, etc. will be recorded in the event
header, followed by the measurement data. If more than 900
measurement intervals are recorded in one event, a new
event will be created automatically.
Datalogging pause
Under the following conditions, the datalogging will be
paused automatically:
1) When entering programming mode, datalogging will stop.
Upon exiting the programming mode, the datalogging will
resume.
2) When entering PC Communication standby mode,
datalogging will stop. Upon exiting the PC communication
standby mode, datalogging will resume
only if datalogging
mode was set to automatic mode.
In either case, a new datalog event will be created when the
datalogging is resumed.
Содержание MultiRAE PLUS PGM-50
Страница 165: ...APPENDIX A A 2 Change LEL VOC Gas Selection Enable Disable Sensor Change Dilution Ratio Change PID Lamp Type N Y Mode N...
Страница 169: ...APPENDIX B B 4 sensitivity to the gas is higher than that of isobutylene VOC or methane LEL...
Страница 176: ...APPENDIX C C 7...
Страница 183: ...APPENDIX G G 2 RAE Systems Service Department...
